​​Welcome to Sino Beverage Machinery Co., Ltd
Set as home page※Add as favorites
Sino Bema
Welcome to Sino Beverage Machinery Co., Ltd

Technical support
HOME ≡ Machinery Academy ≡ Common problems during the bottle stretch blowing process. Part 4

We provide 24 hours technical support for all clients all over the world. 

  1. Manual & operation instruction.

  2. Advice for Installation and machines' breakdown. 

  3. Before purchase consultation.

  4. After-sales service.

Machinery Academy​:

Common problems during the bottle stretch blowing process. Part 4
From:sinobema tech | Edit :insomila | Time :2018-05-13 | 1819 Visit | 🔊 点击朗读正文 ❚❚ ▶ | 分享到:
Some problems happen during the blow molding process, and we will record then and solve them, then share this knowledge to all of you. And we hope that we can discuss more and learn more by doing this. Here is the Part 4

l  .Reduce the temperature for the thin part on the preform.

l  .Increase the temperature for the thicker part on the preform. Just to make the stretching for the both part will be right, and they can get to the same step. Something like giving the poor more and the richer less. That means, we will need to find the balance point for for heating temperature.

 

 

From www.sinobema.com  Sino Beverage Machinery Co., Ltd China 施诺机械设备有限公司中国