​​Welcome to Sino Beverage Machinery Co., Ltd
Set as home page※Add as favorites
Sino Bema
Welcome to Sino Beverage Machinery Co., Ltd

Technical support
HOME ≡ Machinery Academy ≡ Common problems during the bottle stretch blowing process. Part 3

We provide 24 hours technical support for all clients all over the world. 

  1. Manual & operation instruction.

  2. Advice for Installation and machines' breakdown. 

  3. Before purchase consultation.

  4. After-sales service.

Machinery Academy​:

Common problems during the bottle stretch blowing process. Part 3
From:sinobema tech | Edit :insomila | Time :2018-05-11 | 1861 Visit | 🔊 点击朗读正文 ❚❚ ▶ | 分享到:
Some problems happen during the blow molding process, and we will record then and solve them, then share this knowledge to all of you. And we hope that we can discuss more and learn more by doing this. Here is the Part 3

l  .Bottom of the preforms are too thick.

l  .Mechanical problem.

l  .Temperature for the preforms bottom part is not enough. Especially for the flatter bottom bottles. This kind of situation may happen more than other kinds of bottle design.

You can also check the Problem N.4 in this previous article too. And check the reasons in a comprehensive way, and you will find out the solutions.